Alaska Pro-Knife Bill Vote Today—Contact Now!

According to Knife Rights, the Alaska House will vote today on House Bill 33 which, if passed, would ensure one-hand and assisted-opening knives are not considered gravity or switchblade knives. If you live, work or travel in Alaska, please contact your representative(s) and ask them to vote in support of HB33.

Yesterday, Knife Rights Director of Legislative Affairs Todd Rathner testified at a hearing of the Alaska House Judiciary Committee on HB33 “Definitions of Gravity Knives and Switchblades,” referred to by primary sponsor Rep. Mark Neuman as the “Knife Rights Bill.”  The bill also includes Knife Rights’ requested Knife Law Preemption. HB33 advanced out of committee without dissent and now goes to the full House for a vote.

House Speaker Mike Chenault and Rep. Max Gruenberg co-sponsored HB33. The bill is nearly identical  to last year’s HB55, which was passed by the House but was not heard in the Senate. “With changes to the Senate after the 2012 election, we are anticipating better luck in affecting change in Alaska’s knife laws this time around,” Knife Rights reported.

Preemption ensures citizens can expect consistent enforcement of knife laws everywhere in a state. Preemption prevents the creation of or eliminates a patchwork of local ordinances and laws more restrictive than state law, which serves to confuse or entrap those traveling within or through the state.

When contacting the representative, all that is necessary is to simply ask him/her to vote in favor of HB33. Keep it short and to the point.

For more information visit www.kniferights.org.

Tennessee Knife Rights Bill to Senate Vote—Contact Today!

Knife Rights reports that Tennessee Senate Bill SB1015, which would enact the state’s Knife Law Preemption, repeal Tennessee’s antiquated ban on automatic knives (switchblades) and repeal the the state’s 4-inch knife length limitation, has been voted out of committee with a 7-1 vote of recommendation for passage. Requested by Knife Rights and sponsored by Sen. Mike Bell, the bill now moves to the full Senate.

Preemption ensures citizens can expect consistent enforcement of state knife laws everywhere in a state. Preemption prevents the creation of, or eliminates, a patchwork of local ordinances and laws more restrictive than state law which serve to confuse or entrap those traveling within or through the state. Knife Rights has helped pass similar Knife Preemption Laws in Arizona, Utah, New Hampshire and Georgia and helped repeal knife bans in New Hampshire, Washington and Missouri.

If you live, work or travel in Tennessee, please contact your senator and ask him/her to vote Yes on SB1015.

Whether writing or calling, all that is necessary is to simply ask them to vote in favor of SB1015. Keep it short and to the point.

For more info visit www.KnifeRights.org.

Zac Brown’s Southern Grind Headlines New BLADE®

BL0513CVRDo you know Zac Brown of the Grammy-Award-winning Zac Brown Band owns his own knife company? Find out all about it and much more in the new May BLADE®, on many newsstands NOW!

Based in Atlanta, Brown’s knife company is aptly named Southern Grind and focuses on Brown’s lifelong love affair with knives. Get all the poop on it in the May BLADE.

Also in that issue:

•Wally Hayes shows you how to make a Steampunk tanto (his version of which also happens to be the May issue’s cover knife);

•Industry pros select the top 13 knives of the custom pioneers;

•Six knives tackle the deepest, darkest jungles of the Amazon;

•Industry pros show you how to identify knives with proper fit and finish;

•See which factory knives finished as runners-up in the voting for the Blade Magazine 2012 Knife-Of-The-Year® Awards;

•In part IV of a series, Ed Fowler continues to outline how he installs sheep-horn handles on his custom knives;

•And much more!

Also, act before tomorrow and enjoy 74 percent savings on a BLADE subscription. Click on http://www.shopblade.com/blade-magazine-one-year-subscription-us?lid=ssfbbl022713 for more info.

Stop New Jersey from Instituting Knife-Free Zones!

New Jersey has a bill pending that would establish “knife-free zones” around schools, parks and “public facilities,” according to Knife Rights.

New Jersey Assembly bill A1387, which would permit municipalities to establish huge swaths of “weapons free zones” around schools, parks and “public facilities” within which possession of “any dangerous knife” would be prohibited, under penalty of fine and imprisonment, was passed by the full Assembly, along with a package of 19 other anti-gun bills, by decidedly partisan votes.  HOWEVER, THIS BILL HAS NOT YET BECOME LAW.

The bill now moves to the NJ Senate, a somewhat more deliberative body where all indications are that there is no desire to steamroll the bill package that passed in the Assembly. A1387 will face brand new scrutiny and a full committee hearing in the Senate, if it is even moved forward there at all. Not all the bills passed by the Assembly Feb. 21 will even get a hearing in the Senate. In any case, Knife Rights officials say chances will be better to remove the “any dangerous knife” language during a hearing process, which was bypassed in the Assembly.

“We will alert you to act if and when the bill begins moving in the Senate process and it is time to write and call NJ’s senators about this insanity,” the Knife Rights report stated.

There are so many issues with this bill, specifically the “dangerous knife” provision, it’s hard to know where to start.

First, there is no definition of “dangerous knife,” a legally vague and ambiguous term that could apply to anything from a Swiss Army Knife to kitchen knives. As such, it will be left entirely up to cops on the street and then courts to determine what is or is not a “dangerous knife.” There is a huge potential for abuse of honest citizens by any cop, prosecutor or judge with an agenda or prejudice, as has been amply demonstrated for the last several years in New York City, which stimulated Knife Rights’ pending Federal Civil Rights lawsuit against the City and DA. The “dangerous knife” provision was added to the bill after a committee hearing last week from the Assembly floor and without any public hearing on the new provision!

The definition of “public facilities” is extremely broad and simply driving down many streets or walking past a park or through or past a public space would put citizens at risk in a state that has virtually defined “unreasonable” in regards to similar existing restrictions on firearms. The knife provision puts tradesmen who use knives for their jobs at risk, along with anyone who carries a common folding knife. It would also turn utility knives in hardware or convenience stores into illegal contraband if the stores are within the “weapon free” zones.

As but one example, were this legislation to pass and a “weapons free zone” be enacted by Jersey City, New Jersey, which is likely considering the Mayor’s extreme anti-weapon sentiment, anyone attending or exhibiting at the East Coast Custom Knife Show or New York Custom Knife Show in Jersey City could be subject to arrest at numerous points in their journey. It is virtually impossible to get to the shows’ hotel without encroaching on one or more of the proposed “weapons free zones.” (The irony is that these shows moved out of New York City to New Jersey to escape persecution by the anti-knife District Attorney, Cyrus Vance, Jr.)

Finally, as with all such laws, the potential impact on crime is to actually increase the risk to law-abiding citizens within these “weapons free zones” without any positive impact on school or public safety. These gun or weapon free zones simply create a victim-rich location where it is advertised to criminals and madmen that their victims will be unarmed and defenseless.

For more info click on http://www.kniferights.org/index.php?option=com_content&task=view&id=218&Itemid=1

Steel That Changed History in April BLADE®

The steel that changed knives forever, the hottest knives of the hottest custom makers, how to build an emergency shelter and much more highlight the April BLADE®, on most newsstands NOW!

Blade Magazine Cutlery Hall-Of-Fame© member Bill Moran introduced modern damascus knives 40 years ago this year at the Knifemakers’ Guild Show, and those who were there remember it and the impact it has had on the knife industry since.

The hottest knives of the hottest makers change constantly. Find out what the knives are and who makes them in “On The Boil!”

Bushcraft remains hot, as does survival in disaster situations. James Ayres shows you how to build an emergency shelter with your knife in a short amount of time in “Shelter From The Storm.”

Want to know what will be the hot factory knife collectibles down the road? BLADE Managing Editor Joe Kertzman picks the brains of the pros and tells you in his story.

There’s much more: a test of a brut de forge knife, Ray Kirk’s giveaway knife for the upcoming Arkansas Custom Knife Show, a profile of knifemaker Will Zermeno and his cool tactical folders, how to clean a hunting knife, the latest mid-tech knives, Chad Nichols’ MokuTi knife material and much more—all inside the April BLADE with Jim Burke’s Villain Super Sonic on the cover.

To subscribe to BLADE click on www.shopblade.com/blade-magazine-one-year-subscription-us?lid=ssfbbl013013BL0413CAN_final

Jensen Art Knife in Contemporary Crafts Exhibition

One of knifemaker John Lewis Jensen’s classic art knives is in the Mesa Art Museum’s 34th Annual Contemporary Crafts Exhibition, Jensen announced in an e-mail release.

Located in Mesa, Arizona, the museum will feature the knife as one of 47 selected pieces in a highly competitive juried exhibition through March 31.

For more information visit www.mesaartscenter.com or http://www.jensenknives.com.

John Lewis Jensen
John Lewis Jensen

Benchmade Hires David Fee as VP Sales/Marketing

0

Benchmade Knife Company has announced that David Fee will be the new Vice President of Sales and Marketing. The position involves all sales and marketing activities for Benchmade at their headquarters in Oregon.

“We’re thrilled to have David join the Benchmade senior management team,” said Les de Asis, founder and CEO of Benchmade Knife Company, in a news release. “His background and success in the consumer product and automotive industries will help drive our sales, marketing and new products initiatives as we continue to grow and compete on a global scale.”

Click here to visit the Benchmade website.

Advertisement

Must Read Articles

Read this before you make a knife

Knifemaking 101 – Read This Before You Make a Knife

  by Wayne Goddard My experience has taught me that there's nothing like digging in and getting started. I've often said the hardest part of the...
how to forge damascus steel

How to Forge Damascus

Advertisement
Advertisement